How To Program Your Wireless Keypad

Wireless Keypad (Model OWK-BX)

Basic Instructions

Testing Garage Door Opener

  • Enter your personal identification number (PIN).
  • Press the button with the arrow up/down triangles.

Resetting/Clearing Keypad

  • Press and hold the PROG button. Keep holding and proceed to step two.
  • Press and hold the 6 button. Keep holding and proceed to step three.
  • Press the key with the arrow up/down triangles.

Setting PIN On Keypad

  • Press the following keys in order: 3, 5, 7, PROG (red LED blinks once per second).
  • Enter your PIN (three to eight characters).
  • Press the PROG key again (red LED blinks twice per second and turns off).

Getting Started

Before you begin, be aware of the following:
For convenience, program your keypad before mounting.If programming your garage door opener is disrupted at any point due to program failure, clear/reset your keypad. Then, start over. Locate the “Learn Code” button and the “Learn Code” red LED indicator.

Programming One Garage Door Opener

  • Press the “Learn Code” button once (red LED indicator will blink).
  • Enter your PIN.
  • Press the button with the arrow up/down triangles. The “Learn Code” indicator LED will stay on.
  • Press the button with the arrow up/down triangles a second time. The “Learn Code” indicator LED will turn off.
  • Press the button with the arrow up/down triangles a third time. Garage door should now move.

Programming Two Or Three Garage Door Openers

All garage door openers will use the same PIN.

Programming The Wireless Keypad

  • Enter your PIN and press the PROG button (red LED blinks once per second).
  • Press the PROG button a second time (red LED blinks twice per second).
  • Press the total number of doors you wish to control (either 2 or 3).
  • Press the PROG button a third time (red LED blinks several times and turns off).

Programming Garage Door Opener

  • Decide which door will be Door 1, 2 and 3. “Learn Code” indicator LED (on opener) blinks.
  • Enter your PIN and press the arrow up/down triangle button. “Learn Code” indicator LED continues to blink.
  • Press the number you have picked for this door opener: 1, 2 or 3. “Learn Code” indicator LED stays on.
  • Press the arrow up/down triangle button a second time. “Learn Code” indicator LED turns off.
  • Press the arrow up/down triangle button a third time. Garage door should move.
  • Repeat steps one through five for programming each garage door opener. Each door opener must be programmed to receive the signal from the wireless keypad. 

Troubleshooting Tips

  • If the garage door does not move, check the red LED on the keypad.
  • If the LED blinks rapidly, the PIN was entered incorrectly.
  • Any keypad button will control the door for 30 seconds after the door starts moving.
  • Rapid blinking of the LED indicates an error. After a few seconds, the LED will turn off, and you can retry.
  • If the red LED does not blink during use, the battery needs to be changed.

Mounting Instructions

  • Remove the battery cover.
  • Drill a 1/16" hole for the top mounting screw.
  • Install a screw into the top drilled hole, leaving a 1/8" gap between the screw head and the wall.
  • Hook the keypad over the screw.
  • Mark the bottom hole, then screw in the bottom screw.
  • Reinstall the battery cover.

Additional Assistance

Should you need additional information about installing or programming your garage door opener or remote, please call customer service at 865.573.1950, or contact us.